4-1 Cutting Using the Small Work Plate
Chapter 4 Feature Reference
41
Cutter Installation and the Cutting-start Location Setting
CAUTION
Do not touch the tip of the blade with your fingers.
Doing so may result in injury.
1.
Install the cutter, and make the setting for the Z origin position.
➊
Attach the cutter holder, and collet.
➋
Lower the spindle and bring the tip of the collet close to the surface of the workpiece.
➌
Insert the cutter.
Make the tip of the cutter touch the surface of the
workpiece, and tighten the tool securing screw.
➍
Using the operation panel screen, select
[Set the Z origin here].
Click [Set].
The Z origin has now been set.
2.
Make the setting for the XY origin point.
➊
Move the spindle to the cutting-start location.
➋
Select [Set the XY origin here].
Click [Set].
The XY origin has now been set.
Hexagonal screw driver
(small)
Tool securing screw
Summary of Contents for JEWELA JWX-10
