Roland FC-300, Owner'S Manual

Page: 31 / 72

31
Patch Mode
You can connect separately available footswitches and expression pedals and use the
external pedals just like the FC-300’s pedals to transmit Control Change messages,
Realtime messages, and other such data.
When a BOSS FS-5U, FS-6 Footswitch is Connected,
Assigned to CTL Pedal:
These function in the same way as the FC-300’s built-in control pedals.
Connect a control pedal to the EXP PEDAL/CTL jack and set the FC-300 to enable
use of the pedal. (p. 50)
* If you have two FS-5U pedals or an FS-6 pedal connected to the CTL3,4 jack with a special
PCS-31 connecting cable (from Roland; available separately), the footswitch connected to
the plug with the white ring controls the setting of CONTROL 3, and the footswitch
connected to the plug with the red ring controls the setting of CONTROL 4.
* When only one footswitch is connected to the CTL3,4 jack, the CONTROL 3 settings are
enabled.
* When an FS-6 is connected to the CTL3,4 jack with an optional connection cable
(stereo 1/4” phone
←→
stereo 1/4” phone), pedal switch B operates according to the
CONTROL 3 settings, and pedal switch A operates according to the CONTROL 4
settings.
When a Roland EV-5, BOSS FV-500L or FV-500H is
Connected, Assigned to Expression Pedal:
These function in the same way as the FC-300’s built-in expression pedals.
Connect a expression pedal to the EXP PEDAL/CTL jack and set the FC-300 to
enable use of the pedal. (p. 50)
* These do not operate as expression pedal switches.
* If you are connecting a BOSS FV-500L or FV-500H, connect the pedal with an optional
connection cable (stereo 1/4” phone
←→
stereo 1/4” phone).
Each pedal is set at the factory as shown below.
Using the External Control Pedals and Expression Pedals
The Controller Number of Each Pedal
Pedal CC# Range Mode
CTL3 76 0–127 LATCH
CTL4 75 0–127 LATCH
CTL5 10 0–127 LATCH
CTL6 91 0–127 LATCH
CTL7 11 0–127 LATCH
CTL8 64 0–127 LATCH
EXP PEDAL 3 76 0–127 –
EXP PEDAL 4 10 0–127 –
EXP PEDAL 5 11 0–127 –
For details about the all
parameters and changes the
setting, refer to
“Change the
Pedal Settings” (p. 42).
See “Making the
Connections” (p. 11) for
instructions on setting the
polarity switch and mode
switch for the connected pedal.
You can set the range for
values that are transmitted,
refer to
“Change the Pedal
Settings” (p. 42).
FC-300_e1.book 31 ページ ２００７年４月２４日 火曜日 午前１０時１０分