Posi'on Slider Tab
12.
Now slide the Position Slider tabs outboard until they touch the back of the FPE end supports
leaving no gaps.
Fig A
Slide the outer under-cover into place and mark with a pencil for length, remove and cut.
Tip: Cut
approx. 1/8” or 2mm longer than needed to avoid gaps.
Slide under-covers into place and replace
the end caps and lock in place.
13.
Apply car position stickers to the inside of the
End Support cover doors. This will help reposition
the cross bars if removed later.
Fig B
Push and tug on the now installed cross bar
assemblies to check for tightness in all 4 mounting
positions. If any looseness is detected, review the
installation steps and redo until completely firm.
Fig. C
Store your ROLA torque wrench in the vehicle’s
glove box or some other safe storage place.
CAUTION: Check the tensioning bolt torque reading
periodically on long trips or if the cross bars remain
on the car for long periods of time.
14.
Close and lock the end support covers by turning the
quarter turn plugs to the locked icon position.
INSTALLATION INSTRUCTIONS
PAGE 11
!
Fig. A
Fig. C
Fig. B
FR
RR
RL
