Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
59742N Rev G 4-19-16
Product Code:
Product Name:
59742
Printed in China
Pick-Up-
Rack™
Printed in China
7
M10 Flat Washer
M10 Lock washer
M10 Hex nut
(8) Places
Please read all instructions carefully before assembly, installation and/or use of this product.
Remove end cap and buffer
strip to utilize Accessory T-
Slot in crossbar
Buffer strip
WARNING
Always secure front and rear of long
loads to ends of vehicle for safe
transport. Failure to do so can result
in property damage, personal injury, or
death.
REMOVE YOUR RACK AND
ACCESSORIES WHEN NOT
IN USE AND BEFORE
ENTERING AUTOMATIC
CAR WASHES
8
M8 Lock Washer
M8 Hex Nut
M8 Lock Washer
M8 Button Head Screw
•
Raise corner brace into position and attach the top of brace to M8 T-bolt
in crossbar using (1) M8 hex nut and lock washer as shown.
Note: Adjust under covers so corner brace sits flat against crossbar.
•
Next, install the M8 Button head screw and lock washer into the rivet nut
in vertical support tube.
•
Securely tighten all M8 fasteners to 25 Lb.-Ft. (34 N*M)
Note: M5 hex wrench provided for button head screw.
•
Repeat steps for all four corner braces.
under
covers
Page 5 of 7
•
Secure crossbars to supports using the M10 flat washer, lock washers and hex nuts
onto carriage bolts.
•
Securely tighten all M10-1.5 fasteners (approximately 25 Lb.-Ft. )
•
Confirm position of supports and ensure alignment of supports with bed and
securely tighten clamps.
•
Tighten wing nut against bottom of clamp.
Clamp
Wing nut
Support
Optional permanent mounting
Your Pick-Up-
Rack™ can be permanently mounted to your truck if you desire. You will need (8) M10
-1.5 Grade 5 hex bolts, (16) M10 flat washers and (8) M10-1.5
grade “A” lock nuts. Stainless steel hardware is recommended. Start by placing a piece of tape on top of the mounting base.
Mark the tape as shown below. Place
the mounting base on the truck and check that there will be no interference where the bolts will be placed. Remove the base from the truck and drill the (2) 10mm
holes in the marked locations on the base. Mark the truck bed rails using the drilled base as a template. Then drill the (2) 10mm holes in truck bed rail, 4 places.
Place a M10 washer on a M10-1.5 bolt and insert it though the base
and truck bed. Install a M10 washer and M10-1.5 nut on the bolt
underneath the bed rail and tighten.
Support Base
75
MAXIMUM
DRILL (1) 10 HOLE
THIS LOCATION
25
MINIMUM
CENTER
OF BED RAIL
(62 REF.)
25
DRILL (1) 10 HOLE
CENTER
OF BED RAIL
(62 REF.)
