Roksan Audio ltd
Xerxes.20 Record Player User Manual
General Use
Version 3.0
All specifications are liable to change without notice. E&OE
Page 14 of 22
ENGLISH
Use the 2.5mm A/F Allen Key and looking from the left hand side, adjust the back (3
rd
) screw to tilt the platter
assembly FRONT to BACK as shown above. DO NOT over tighten or slacken the fixing screw too much.
Adjustment of this screw will NOT change the LEFT to RIGHT level.
Belt riding position
The Belt should ride with at lease
2mm clearance from the bottom of
the Inner Platter
NOTE:
•
With the belt riding higher on the
pulley (i.e. more than 1mm gap),
the rotational speed would be
slightly increased.
•
With the belt riding lower on the
pulley (i.e. less than 1mm gap),
the rotational speed would be
slightly decreased.
Drive Belt Set-up and Maintenance
1
If the levels are adjusted but the drive belt rides a little too high,
then remove the belt and gently stretch it. Wait a couple of
minutes and refit the drive belt and the outer platter and check the
running position again (Repeat this process if necessary)
1 mm
gap between the Belt and the
Pulley flange
Ref.
: Pulley flange thickness is 1mm
B
FRONT
BACK
2.5mm A/F ALLEN KEY
