ROJONE Pty. Ltd – 61 Aero Rd, INGLEBURN NSW 2565 AUSTRALIA
TEL +61 02 9829 1555 FAX 02 9605 8812 EMAIL [email protected]
23
Do NOT at any time remove the Rear Panel and attempt to remove the circuit board.
Take the silicon grease sachet and apply a small amount to each of the cables just behind the connectors. This will allow
the Inner Plastic Boot to easily slide back over the connectors and is also needed to improve the waterproofing at the
cable entry into the Boot.
Carefully SLIDE the Inner plastic boot back over the housing and ensure that all connectors are properly mated. Take
the silicon grease and spread it evenly on the outside surface if the Inner plastic boot. That is around the 4 flat sides
covering the box.
Also spread the silicon grease liberally along all 4 edges.
Take the Outer plastic boot and place the water absorbing Desiccant Bag into the bottom of the boot.
