rojaflex WSR-15, Original Assembly And Operating Instructions

Page: 10 / 12

4. Delete wall transmitter
3. Add wall transmitter
At an ALREADY programmed
station, select an already
programmed channel by
pressing the K1 (or K2) key.
Then, at the NEW station to
be learned, select the channel
to be added by pressing the
K1 (or K2) key (the channel
highlighted in black is selec-
ted).
Then press the P2 program-
ming button once on the wall
transmitter to be reprogram-
med.
The motor (shutter) briefly
moves UP/DOWN and/or the
receiver beeps.
OK !
Wall transmitter is added!
Press the P2 programming
button 3 times on the wall
transmitter that has already
been programmed.
P P P
Important: For systems with SI (single-directional system / one-way communication), the P2 key
of the already programmed handheld transmitter is pressed only 2 times!
This applies, for example, to the MLSF/MLMF drives and the REHK-1 and RUE-UP external recei-
vers.
Please follow the instructions of the respective receiver/motor!
Individual deletion of hand-held or wall-mounted transmitters is NOT possible!
For further information, please refer to the instructions of the Rojaflex radio tubular motors or radio
receivers.
1. Power is ON (motor is connected and ready for operation).
2. Press P2 programming key 1 x. Motor beeps 1 x.
3. Press STOP key 1 x. Motor beeps 1 x.
4. Press P2 programming key 1 x. Motor beeps 3 x*.
OK! ALL wall (hand) transmitters are deleted!
*
The frequency of the beeps or the response of the motor / shutter depends on the receiver.
Please observe the corresponding instructions for the respective receiver/motor-.
10
www.rojaflex.com
Programming and settings