8
www.rojaflex.com
To be able to program the sensor, a hand-held or wall transmitter must already be programmed in the cor-
responding receiver (Rojaflex radio motor or radio receiver).
Each keystroke must be executed within approx. 4 seconds!
Otherwise, the system automatically exits the programming mode.
1.
Programming the RVS-01 vibration sensor
1.1
Open the housing and remove the control
unit.
1.2
Set the trimmer to level "0" using a small
screwdriver.
1.3
Press key P2 3 times in succession on an
already programmed handheld transmitter.
1.4
Press the P2 key on the RVS-01 once.
Motor moves up/down briefly.
RVS-01 is programmed.
1.5
Set the desired sensitivity of the sensor on the
trimmer.
-start with a low setting (level 1 or 2).
1.5
Click the control unit into the housing.
1.5
Slide the housing back onto the rear cover.
slide
Sensor beeps briefly and is activated.
2.
Check the function
2.1
The awning's drop profile vibrates oscillate.
CAUTION! Do not move the awning too much!
2.2
After approx. 2-3 seconds, the awning must
retract automatically.
2.3
Change the trimmer setting if necessary.
NOTE!
After the retract command has been triggered by
the sensor, the awning cannot be extended for
approx. 10 minutes (blocking time).
3.
Deactivate the sensor
ATTENTION!
Not recommended, as there is a risk of damage to
the sunshade system when the sensor is
deactivated.
3.1
Set the trimmer to level "0".
When the set vibration intensity is reached, the retract command is triggered with a delay of approx.
3 seconds and repeated 2 times.
3 x P2 - already
taught Handheld
transmitter
1 x P2
RVS-01
1
23
4
5
6 7
8 9
0
+
+
-
-
P2
Trimmer
Function overview
Summary of Contents for RVS-01
Page 9: ...www rojaflex com 9 Notes ...
Page 10: ...10 www rojaflex com Notes ...
Page 11: ...www rojaflex com 11 Notes ...
