RP248CN Users and Installer’s Manual
Page 27
then use[BPY] or
[STAT] to move the
cursor properly
4) Press [ENTER] to
keep on
5) Press [SYP] one
time to keep on
ZONE TEST TIMES
2) Z. TEST PERIOD
6) Press
[ENTER]
ZONE TEST PERIOD
PERIOD: 00 (00-24)
7) Set the interval
time(01-24 hours)
for testing, and
then press
[ENTER]
8)
Press [*] to exit
Set Universal Output to
trigger the noises source
The
background
information of the
Universal Output
For the most skillful
installer, please refer
to 3) Universal Output
1) From
this
INSTALLER PROG
3) UTIL OURPUT
2) Press
[ENTER]
SELECT UO NUMBER
UO=01 (0:1)
3) Select a idle UO
number (ex: UO2)
as the Usual
Output noises
source; then press
[ENTER]
UO=02 FOLLOWS:
0) NOTHING
4) At this display,
press [1] to select
the system
UO=02 FOLLOWS:
1) SYSTEM
i. Press
[ENTER]
SYS.EVENT: UO=02
1) BELL FOLLOW
ii.
At this display, press
[8]
SYS.EVENT: UO=02
8) SENSORS TEST
ii. Press
[ENTER]
PATTERN UO=01:
2) PULSE N/O
v.
At this display, select
the UO operate way;
a typical way: select
PULSE N/O; UO port
is like a N/O switch, it
can be closed at the
preset time and the
loop current will start
the noises source;
press [ENTER]
v.
At this display, you
can verify or change
your selected output,
press [ENTER];
LABEL FOR UO=02:
OUTPUT 02
Then press
[ENTER]; if
necessary, please
press [*]
6.5.4 Programmable Utility Output
Hot Key
Output
Def
ault
Instruction
[0] Nothing Yes
[1]
System
Response system events
[1][1] Event
