38
12.3. Power on
When you connect the unit to the power supply, all icons will appear on the display for 3
seconds. After the automatic verification and if the equipment is working properly, the unit
enters standby mode, the following information will appear on the display.
12.4. Clock settings
When the device is switched on, press the button
to access the clock settings. The icons
88:88 hours and minutes will flash simultaneously.
To activate the hour and minute settings, press the button
and use the buttons
to
set the hours and minutes.
Press the button
again to confirm the setting and exit the clock.
12.5. Locking the control panel
Press the buttons
simultaneously and hold for 5 seconds to lock the control panel.
Press the buttons
simultaneously and hold for 5 seconds again to unlock.
12.6. Switch on
Press and hold the button
for 2 seconds while the unit is in standby mode. After this it
will turn on and start the “Warm-up mode”.
On the left side of the screen, under the words SET TEMP, we will see the temperature set
for the water (the temperature at which we want the water to be). On the right side of the
screen, under the words WATER TEMP, we will see the current temperature of the water
contained in the water tank.
Summary of Contents for Dalis Pro 200DHW5
Page 52: ...52 NOTES ...
Page 53: ...53 DALIS PRO DOMESTIC HOT WATER HEAT PUMP EN NOTES ...
Page 54: ...54 NOTES ...
Page 55: ...55 DALIS PRO DOMESTIC HOT WATER HEAT PUMP EN NOTES ...
