9
AGILITY CARBON Back System Operation Manual
3. Use a tape measure to make sure the
cane clamps are at the same height.
Adjust the height if needed and
re-tighten the hardware.
1. Use the T-Handle Wrench to remove
the cane clamp screw and the outer
cane clamp. Repeat for the other
side.
2. Place the inner cane clamp around the cane.
Attach the outer cane clamp, using the T-Handle
Wrench. Repeat for other side. Slide the back up
and down to the desired height. Tighten the cane
clamp screws until snug + one-quarter turn.
Note: If a torque wrench is available, tighten to no
more than 40 inch-pounds (4.5 Newton-meters).
Installation and Height Adjustment
Warnings:
-
DO NOT install, remove, or adjust the height of AGILITY CARBON while the individual is seated in the wheelchair.
-
After you install AGILITY CARBON, and before the individual transfers into the wheelchair, make sure that all hardware is securely
tightened. Refer to the recommended torque specifications.
Installation Options:
Follow the instructions for
i
nstallation
o
ption
a
t
o install AGILITY CARBON on your wheelchair
.
If your wheelchair canes have push handles or
other equipment that may interfere with installation, follow the instructions for
i
nstallation
o
ption
b
.
Installation Option B
Installation Option A
3. Use a tape measure to make sure the
cane clamps are at the same height.
Adjust the height if needed and
re-tighten the hardware.
1. Use the T-Handle Wrench to loosen,
but not remove, the cane clamp
screw. Repeat for the other side.
Note: If the outer cane clamp
becomes detached see Step 2
under Installation Option A.
2. Slide the cane clamps onto the canes to the
desired height. Use the T-Handle Wrench to tighten
the cane clamp screws until snug + one-quarter
turn.
Note: If a torque wrench is available, tighten to no
more than 40 inch-pounds (4.5 Newton-meters).
Have the individual safely transfer into the wheelchair.
