8
AGILITY CARBON Back System Operation Manual
Hardware Re-assembly
If over-rotation occurs during Angle Adjustment
,
and the angle adjustment discs in the back shell and inner cane clamp come loose, follow
the instructions below. After re-assembly
,
follow all angle adjustment and installation instructions provided in this manual.
3. Place the back cane hardware onto the back shell. For
correct orientation make sure the bumps on each disc
are lined up at opposite ends, as shown.
2. If a disc has separated from the inner cane clamp, you will
need to put it back in place: Press the disc into the grooves
on the inner cane clamp.
Disc
1. If a disc has separated from the back shell, you will need
to put it back in place: Press the disc into the grooves on
the back shell.
4. Before you attach the back cane hardware to the back
shell, make sure the angle adjustment markers on the
back shell and inner cane clamp are aligned.
5. Replace and tighten the angle adjustment screw using the
T-Handle Wrench.
Note: If a torque wrench is available, tighten to no more
than 60 inch-pounds (7 Newton-meters).
Disc
bump
bump
