RB-D610Q327TB48 User
’
s Manual
FEBL610Q327RB
1
1. Overview
This instruction manual is for the RB-D610Q327TB48 which is the reference board for ML610Q327 (hereinafter referred to
as "MCU") that is 8-bit microcontroller with voice output function.
This board can be combined with on-chip debug tool EASE1000 V2 and software development enviroment(DUT8 and
MWU16) to do the following:
-
Development and debugging of the MCU control software.
-
Programing control and sound code data to the MCU internal Flash-ROM.
-
Voice playback by the MCU.
2. Operational notes
The following describes the precautions to follow when handling the RB-D610Q327TB48.
-
Turn off the power when inserting and removing jumper socket from PWR/SPVDD/VREF Jumper pin on the RB-
D610Q327TB48.
-
Turn off the power when attaching and deattaching external board, device and cable from CN1/CN2/CNE Connector on
the RB-D610Q327TB48.
-
Connect only monaural speakers to the jack on the RB-D610Q327TB48.
-
RB-D610Q327TB48 is a device used only by experts in R&D facilities for research and development purposes. RB-
D610Q327TB48 is not intended to be used in mass-produced products or parts thereof.
-
The information in this document is subject to change without notice due to product improvement and technological
improvement. Prior to use, please ensure that the information is up to date.
-
LAPIS Technology does not provide any RB-D610Q327TB48 support. Replace only in case of initial failure.
3. Hardware specifications
Table 1 shows the hardware specifications of RB-D610Q327TB48. For more information about the connection of the mounted
components, see the schematic.
Table 1
Hardware specifications
Mounted LSI
・
U1: ML610Q327 48pin TQFP
Other Mounted
components
・
PWR(J1): Jumper for selecting the power supply input (3pin pin-header and short pin)
・
VREF(J2): Jumper for selecting VREF(3pin pin-header and short pin)
・
SPVDD(J3): Jumper for selecting SPVDD(3pin pin-header and short pin)
・
C1-C4: Capacitors for Powers
・
P22-P24: LEDs
・
R1-R3: Resistors for LEDs
・
R4-R6: Jumper Chip for connecting LEDs
・
R7-R10: Resistors for Successive Approximation Type A-D Converter
・
JACK: Jack for connecting Speakers
・
CNE: Connector for EASE1000 V2(14pin connector)
Pads (or/and)
Through holes for
mounting components
・
C5-C8: Capacitors for Successive Approximation Type A-D Converter
・
CN1-CN2: Connectors for user application system (32pin, 2.54mm pitch, φ0.8mm )
・
SP1: Land for ferrite beads(1608)
Power check pins/pads
・
VDD
、
SPVDD
、
UVDD
、
USPVDD
、
VSS
、
SPVSS
、
AIN4-AIN7 (φ0.8mm)
Operating voltage
・
+2.0
～
+5.5V
Board size
・
55.88 mm x 93.98 mm
