Commissioning
R&S
®
TS-PWA3
40
User Manual 1157.8143.12 ─ 17
●
The module is correctly located when a distinct 'stop' can be felt
●
Tighten the top and bottom screws on the front panel of the plug-in module
Please observe the following instructions for installation of a Rear I/O module:
●
Rear I/O modules (for example R&S TS-PDC) must be inserted with extra caution,
making certain the connector is correctly guided into the socket opening in the
backplane. It must not be inserted at an angle or with incorrect alignment, etc. The
short circuit board guides alone do not ensure absolutely reliable guiding.
●
Multiple adjacent R&S TS-PDC modules should be inserted in order "from left to
right" and removed in the opposite order. Because the spaces are so narrow, care
must be taken not to damage any components on the solder side of the module.
4.3.4
Driver Installation
The drivers for R&S modules will be installed together with the R&S GTSL software.
The installation procedure is described in the manual
Software Description GTSL
.
For non-RS modules you have to consult the documentation supplied by the module
manufacturer.
4.4
Connections
4.4.1
Line Inlet
The R&S TS-PWA3 requires a supply within the range of 110 VAC / 60 Hz or
230
VAC
/
50
Hz. Fuse protection for the line inlet must not exceed a rating of 16 A.
The PSU used in the R&S TS-PWA3 has
automatic voltage selection
between 100
and 240 Volt AC (see Section 9, Technical Data).
Connections
