Rohde & Schwarz SMM100A, User Manual

Page: 413 / 1088

Configuring the RF signal
R&S
®
SMM100A
413 User Manual 1179.1341.02 ─ 05
A sensor tab contains all parameters for configuring the sensor settings, like aver-
age or peak display, reference source, filter and level offset.
The remote commands required to define these settings are described in
Chap-
ter 13.14, "SENSe, READ, INITiate and SLISt subsystems" , on page 699, including
the triggering of the measurement and the retrieval of measurement results.
Settings:
Sensor type and serial number ................................................................................... 413
Level (Peak) / Level (Average) ....................................................................................413
Sensor Mapping .......................................................................................................... 413
Sensor Settings ...........................................................................................................414
└ State ..............................................................................................................414
└ Zero ...............................................................................................................414
└ Display .......................................................................................................... 414
└ Permanent .......................................................................................... 414
└ Display ................................................................................................ 414
└ Use Frequency Of .........................................................................................414
└ Frequency ..................................................................................................... 415
└ Level Offset State,Level Offset ..................................................................... 415
└ Filter .............................................................................................................. 415
└ Filter Length .................................................................................................. 415
└ Auto Once .....................................................................................................416
└ Noise/Signal Ratio ........................................................................................ 416
└ Timeout ......................................................................................................... 416
└ Default Aperture Time ...................................................................................416
└ Aperture Time ............................................................................................... 416
└ S-Parameter ..................................................................................................416
└ Enable Logging .............................................................................................417
Sensor type and serial number
Indicates the type and the serial number of the selected R&S NRP power sensor, and
the channel the sensor is assigned to.
The displayed Level (Peak) / Level (Average) values correspond to the particular sen-
sor.
Remote command:
:SENSe<ch>[:POWer]:TYPE?
on page 713
:SENSe<ch>[:POWer]:SNUMber?
on page 711
Level (Peak) / Level (Average)
Indicates the measured peak or average level value.
You can also change the unit for the results display: Watt, dBm or dB
μ
V.
Note: Peak level measurements are provided if the power sensor supports this feature.
Remote command:
:READ<ch>[:POWer]?
on page 705
:SENSe<ch>:UNIT[:POWer]
on page 705
Sensor Mapping
Accesses the NRP sensor mapping dialog.
Improving level performance