Rohde & Schwarz SMM100A, User Manual

Page: 713 / 1088

Remote control commands
R&S
®
SMM100A
713 User Manual 1179.1341.02 ─ 05
:SENSe<ch>[:POWer]:TYPE?
Queries the sensor type. The type is automatically detected.
Return values:
<Type> string
Example:
:SENS1:TYPE?
Queries the type of sensor.
Response: NRP-Z21
The R&S NRP-Z21 sensor is used.
Usage: Query only
Manual operation: See "Sensor type and serial number" on page 413
:SENSe<ch>[:POWer]:ZERO
Performs zeroing of the sensor.
Zeroing is required after warm-up, i.e. after connecting the sensor.
Note: Switch off or disconnect the RF power source from the sensor before zeroing.
We recommend that you zero in regular intervals (at least once a day), if:
●
The temperature has varied more than about 5 °C.
●
The sensor has been replaced.
●
You want to measure very low power.
Example: :SENS1:ZERO
Executes zeroing.
Usage: Event
Manual operation: See "Zero" on page 414
13.15 SCONfiguration subsystem
The
SCONfiguration
subsystem contains the commands for defining the system
configuration setting, like stream mapping and used baseband configuration.
Required options
See "Required options" on page 455.
Example: Distributing the I/Q streams to the output connectors
The following example lists the commands necessary to fulfill this task.
// ********************************************************************************
// Map the I/Q streams to the output connectors.
// ********************************************************************************
SCONfiguration subsystem