Rohde & Schwarz SMM100A, User Manual

Page: 160 / 1088

Configuring the internal baseband source
R&S
®
SMM100A
160 User Manual 1179.1341.02 ─ 05
2. Select "Create Test Signal".
This dialog provides settings for configuration of a continuous test signal with con-
stant IQ. The I and Q values for each path are adjustable but constant. For more
information, refer to
Chapter 4.6.2.2, "ARB test signals" , on page 149.
If converted to an analog signal, the signal is output directly at the I and Q connec-
tors of the instrument.
Settings:
I Value, Q Value ...........................................................................................................160
Generate Signal File ................................................................................................... 160
Generate Signal RAM ................................................................................................. 160
I Value, Q Value
Enters the value for the I respectively Q component of the test signal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I
on page 806
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q
on page 806
Generate Signal File
Generates a signal and saves it as a waveform file on the hard disk. Use the standard
"File Select" function to save the file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed
on page 808
Generate Signal RAM
Generates a signal and uses this signal as output straight away. The instrument saves
the file using a predefined filename.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate
on page 808
4.6.3.5 Trigger, marker and clock settings
These tabs provide standard settings.
For detailed description, see:
●
Chapter 4.4.2.1, "Trigger settings" , on page 109
●
Chapter 4.4.2.2, "Marker settings" , on page 112
●
Chapter 4.4.2.3, "Clock settings" , on page 114
Using the arbitrary waveform generator (ARB)