Remote Control Commands
R&S
®
SMF100A
485
Operating Manual 1167.2319.02 ─ 12
Parameters:
<Amplitude>
float
Range:
0 to 3
Increment: 0.1
*RST:
1
Example:
SOUR:LFO:SWE:FREQ:MARK:AMPL 1
The output level is reduced by 1 dB on reaching the mark.
Options:
R&S SMF-B20
Manual operation:
See
" Amplitude - LF Frequency Marker "
[:SOURce]:LFOutput:SWEep[:FREQuency]:MARKer:AOFF
The command switches off all active frequency markers. The command triggers an
event and therefore has no query form and no *RST value.
Example:
SOUR:LFO:SWE:FREQ:MARK:AOFF
switches off all frequency markers.
Usage:
Event
[:SOURce]:LFOutput:SWEep[:FREQuency]:MARKer<ch>:FREQuency
<Frequency>
The command sets the frequency of the selected marker. If the marker is switched on,
the signal level at the MARKER output changes on reaching the frequency mark.
Parameters:
<Frequency>
float
Range:
0.1 to 10E6
Increment: 0.1
*RST:
300 MHz
Example:
SOUR:LFO:SWE:MARK1:FRQ 200Hz
sets the frequency mark for marker 1 to 200 Hz.
Options:
R&S SMF-B20
Manual operation:
See
" Frequency - LF Frequency Marker "
[:SOURce]:LFOutput:SWEep[:FREQuency]:MARKer<ch>:FSTate
<FState>
The command activates or deactivates the selected marker. If the marker is switched
on, the signal level at the MARKER output changes on reaching the frequency mark.
Parameters:
<FState>
0 | 1 | OFF | ON
*RST:
OFF
Example:
SOUR:LFO:SWE:FREQ:MARK1:FST ON
switches on marker 1.
SOURce Subsystem
