Remote Control Commands
R&S
®
SMBV100A
443
Operating Manual 1407.6062.32 ─ 08
{DATA LIST-Length: #d0d1...dx...dN-1…}
(mandatory for data lists)
The tag contains the actual bit sequence of the data list in binary format.
Setting parameters:
Length
Defines the number of bytes in the
DATA LIST
tag in ASCII For-
mat (for format see
WAVEFORM
length).
dx
Data bits in binary format (8-bit unsigned characters, MSB first).
Example:
DATA LIST-17: #d0d1...dx...d127}
16 bytes containing 128 data bits, first bit is the MS bit of the first
byte.
Usage:
Setting only
{DATE: yyyy-mm-dd;hh:mm:ss}
(optional)
The tag contains the date and time at which the file was created. The year must be
expressed as four digits. The instrument does not analyze this tag.
Example:
{DATE: 2009-04-02;14:32:12}
BB:ARB:WAV:TAG? 'DATE'
queries the content of the
DATE
tag of the selected waveform file.
Response: '2009-04-02;14:32:12'
the waveform was created on April 2, 2009 at 14 hrs 32 min
Usage:
Setting only
{CONTROL LENGTH: ControlLength}
(optional / recommended for marker and control lists)
The tag contains the length of the control list in ASCII format. If this tag is not used, the
marker and control list length is determined by the highest position used in one of the
LIST
tags. It is recommended to set this value to be equal to the number of samples in
order to keep marker signals and wave data synchronized.
Example:
{CONTROL LENGTH: 444}
BB:ARB:WAV:TAG? 'CONTROL LENGTH'
queries the length of the control list.
Response: '444'
Usage:
Setting only
{LEVEL OFFS: RMSOffset_dB,PeakOffset_dB}
(recommended for waveforms)
R&S Signal Generator Waveform and List Format
Summary of Contents for SMBV100A
Page 31: ......
