Preparing for Use
R&S
®
Scope Rider RTH
18
Getting Started 1326.1561.02 ─ 05
1. Turn off the instrument power. Remove power supply, probes, test leads and
all other cables.
2. Fold out the tilt stand on the back of the instrument.
3. Screw open the battery cover.
4. Insert the battery pack.
5. Screw down the battery cover.
6. Connect the power adapter to the connector on the left side of the scope, and
fully charge the battery. Charging may take a few hours.
If the instrument is on, the battery status is shown on the display.
Replace used batteries periodically by new batteries after 24 months of
usage.
Observe the safety regulations in the "Batteries and rechargeable batteries/
cells" chapter in the "Basis Safety Instructions" brochure, which is delivered
with the instrument.
Inserting and Charging the Battery
