Overview
Overview of the Rear
2-16
VENICE 2U | Hardware Guide | Version 1.2
Rohde & Schwarz DVS GmbH
2.3.3 Main Connector Panel
The main connector panel provides the standard in- and outputs of
VENICE 2U to give you the full functionality of the system. It holds, for
example, the digital video in- and outputs (serial digital interface) and
the connectors for remote control.
Figure 2-10: Main connector panel on rear (left half)
Pin-outs of most connectors can be found in section “Signal In- and Out-
puts” on page A-7.
The following information may not be valid for all VENICE 2U hardware
variants. Wherever required, not provided or optionally available con-
nectors are indicated for the specific system. No indication in the table
below means that the connector is provided as standard for all
VENICE 2U variants.
Item
Description
Ref In 1/2
BNC connector for the reference input for
channels 1 and 2
For further information about the sync settings,
see chapter ‚Level Administrator‘ in the
“VENICE Client Software“ user guide.
Ref In 3/4
Same as ’Ref In 1/2’ but for video channels 3
and 4
SDI Out 1
BNC connector for an output of digital video
signals (serial digital interface); usually used for
an output of single-link (YUV) or 3-Gbit/s (YUVA
or RGB[A]) video signals for video channel 1;
can also be used for dual-link modes of video
channel 1 (first video stream, port A)
Ref In
SDI Out
LTC Out
SDI In
Digital Audio
