Remote Commands
R&S
®
Spectrum Rider FPH
334
User Manual 1321.1011.02 ─ 06.00
The numeric suffix at CALCulate is irrelevant for this command. The numeric suffix at
MARKer selects the marker.
Example:
CALC:MARK:FUNC:LEV:ONCE
Initiates an automatic level adjust routine.
Usage:
Event
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer:RESult?
<arg0>
This command queries the results of power measurements.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end before reading out the result. This is only possible in single sweep mode.
Before you can use this command, you have to select the power measurement with
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer:SELect
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer[:STATe]
on page 332.
This command is a query and therefore has no *RST value.
The numeric suffix at CALculate and MARKer are irrelevant for this command.
Remote Control - Commands
