Rohde & Schwarz OSP-B200S2, User Manual

Page: 257 / 327

RC Commands
R&S
®
OSP
257 User Manual 1178.7100.02 ─ 05
ROUTe:PATH:LAST?
Queries the name of the previously switched path.
If the previous switching action was based on
ROUTe:CLOSe
+ channel list string
(rather than a path name), the response is
<Individual Settings>
. After a
*RST
command, the response is
<Reset State>
.
In the main page of the switch unit's user interface, the line "Last Switched Path"
(enabled by the
Path Info setting or by
CONFigure:MAINinfo:PATH
) shows the
same information as the response to
ROUT:PATH:LAST?
.
Return values:
<path name> See
ROUTe:PATH[:DEFine]
on page 255
Usage: Query only
Manual operation: See "Path Info" on page 198
ROUTe:PATH:CATalog?
Returns a list of all currently defined path names in the internal volatile memory of the
switch unit.
The query addresses the default directory path "
/home/instrument/ospdata
" in
the internal storage of the R&S OSP, unless you specify a different directory path,
which is optional.
Return values:
<list of path names> Comma-separated list of path names, each in quotation marks.
Example: ROUT:PATH:CAT?
Response: "config_01","config_02","config_03"
Usage: Query only
ROUTe:PATH:DELete[:NAME] <path name>
Deletes the path specified by the <path name> parameter from the switch unit’s inter-
nal volatile memory. If this path does not exist, the command has no effect.
Setting parameters:
<path name> See
ROUTe:PATH[:DEFine]
on page 255.
Example: ROUT:PATH:DEL:NAME "config_03"
Deletes the path with the name
config_03
.
Usage: Event
Manual operation: See "Delete Path Export File" on page 192
ROUTe:PATH:DELete:ALL
Deletes all previously defined paths from the switch unit’s internal volatile memory.
ROUTe Commands