Rohde & Schwarz OSP-B200S2, User Manual

Page: 24 / 327

Getting Started
R&S
®
OSP
24 User Manual 1178.7100.02 ─ 05
Figure 2-2: The module operation dialog, here with a single switch unit and 5 modules
The information in this dialog is updated during the booting process, when the
R&S
OSP automatically scans all its installed modules. The switch unit stores the infor-
mation on these modules in its internal flash memory (SD card).
If you have mounted additional modules or removed original ones, the switch unit
detects and stores this changed configuration of modules. If Module Check is enabled,
the R&S OSP automatically prompts you with information on the changed modules.
If the Virtual Mode is enabled, you can edit the list of frames (switch units) and their
modules.
To check the installed options from a remote computer in the same local area network
as the R&S
OSP, you can use the remote control command
ROUTe:MODule:
CATalog?
on page 295.
2.1.14 Configuring the Initial Instrument Settings
After startup, the switch unit is fully configured automatically, and ready for use.
However, you have many options to change the configuration, for example:
●
Edit the network settings, see Chapter 5.4.3, "Network" , on page 210
●
Define or modify a setup of primary and secondary switch units, see Chapter 5.4.4,
"Interconnection" , on page 212
●
Restore a previous setting, see "Backup/Restore" on page 215
●
Define switching paths and output channels, see "Manage path selection:"
on page 185
Configuring a setup of primary and secondary switch units is described in Chap-
ter 5.4.4, "Interconnection" , on page 212.
Preparing for Use