Rohde & Schwarz CMW-KE100, User Manual

Page: 43 / 938

1xEV-DO Signaling
R&S
®
CMW-KM8xx/-KS8xx
43 User Manual 1173.9511.02 ─ 12
The IP statistics table in the lower part of the view contains the following rows:
●
"PPP Total Bytes": Total number of bytes the R&S CMW received (Rx) and sent
(Tx) since the beginning of the PPP connection
●
"Data Rate": Current received data rate in kbit/s, averaged over the update period.
For the test procedure refer to "Data RX measurement procedure" on page 35.
2.3 GUI Reference
The following sections provide detailed reference information on the parameters of the
1xEV-DO signaling application. Most of the signaling parameters are arranged in the
"1xEV-DO Signaling Configuration" dialog. Additional dialogs allow to configure the
measurements included in the signaling application.
Many of the signaling parameters are available in a subset of connection states only
(e.g. handoff is only possible when a connection is established). Temporarily unavaila-
ble parameters are grayed out in the configuration dialogs; hotkeys appear and disap-
pear dynamically, depending on the connection state.
The screenshots in this chapter show the GUI with all available options installed.
Depending on the installed options some parameters may not be configurable (display
the default value) or may not be visible at all. This is indicated in the parameter
description.
The GUI reference is structured as follows.
● Signaling View .........................................................................................................43
● Signaling Control .....................................................................................................50
● Using the Shortcut Softkeys ....................................................................................52
● General Settings ..................................................................................................... 53
● I/Q Settings ............................................................................................................. 54
● Internal Fading ........................................................................................................ 56
● System Settings ...................................................................................................... 60
● Layer ....................................................................................................................... 70
● Network ...................................................................................................................87
● Shortcut Configuration ............................................................................................ 97
● Message Monitoring ................................................................................................97
● RX Measurement .................................................................................................... 98
2.3.1 Signaling View
The signaling view shows status information about the cell and the attached access
terminal, information derived from the reverse signal and the most important settings.
Most settings in this view can also be accessed via the configuration dialog.
For a description of available hotkeys refer to chapter 2.3.2, "Signaling Control" ,
on page 50
GUI Reference
深圳德标仪器
135-1095-0799