Maintenance, storage and disposal
R&S
®
AMN6500
25
User Manual 1352.1213.02 ─ 01
6
Maintenance, storage and disposal
Before any maintenance work on the R&S
AMN6500 is executed, read the
The device does not need to be regularly maintained. Maintenance is limited essen-
tially to wiping the device's external surfaces. See
6.1
Device safety inspection
A device safety inspection of the network as defined in BGV A3 is not possible
because of the design according to CISPR 16-1-2 (EN 55016-1-2) and measurement
set-up according to CISPR 16-2-1 (EN 55016-2-1). Therefore, the following examina-
tions must be carried out as a minimum requirement.
6.1.1
Visual inspection
Ensure that parts relevant for active and passive safety are not visibly damaged or
even unsuitable for use in the device.
1. Remove the R&S
AMN6500 from the mains supply.
2. Let the R&S
AMN6500 cool down to ambient temperature.
3. Check the following parts for damage:
a) Housing, displays, carrying handles, air vents
b) Device connection cables, connection points and mains lead cleats
c) Mains plug, fuse holder
d) Labeling and markings, warning notices
e) Isolated parts, wiring insulation
f) Plug connections and clamping points
g) Vent and leakage paths must not be altered unacceptably.
If any damage is detected, remove the R&S
AMN6500 from the test environment
and contact R&S customer support. See
Chapter 6.2, "Contacting customer sup-
6.2
Contacting customer support
Technical support – where and when you need it
For quick, expert help with any Rohde
&
Schwarz product, contact our customer sup-
port center. A team of highly qualified engineers provides support and works with you
Contacting customer support
