Specifications
It is a requirement that licensed technicians carry out all installations required of this product.
All installations should comply with the relevant requirements, local codes and building and plumbing standards.
Shower may not be suitable for use with gravity-fed water heaters, low and unequal pressure supply networks,
instantaneous water heaters tempering valves and thermostatic mixing valves
.
Care should be taken when installing the shower such that the flow controller is not damaged during installation
.
Water Pressure:
[1] Maximum Hydrostatic Pressure: 1000kpa. This pressure may be exceeded only under test conditions as per AS/
NZS 3500. Where hydrostatic pressure exceeds the maximum stated above, pressure-limiting valves should be
installed. [2] Recommended Maximum Hydrostatic Pressure: 500kpa (AS/NZS 3500)
[3] Recommended Minimum Hydrostatic Pressure: 150kpa
Temperature:
Maximum Water Temperature: 80° C. For optimum performance, hot and cold inlet water pressure should be equal.
Care and Maintenance
[1] Product should be inspected for surface damage prior to installation. [2] Cleaning and handling of all
finishes must be performed carefully. [3] Clean products using a soft cloth with warm soapy water only. [4] Never
use harsh detergents or abrasive cleaners as these will damage the product. [5] Water marks can be removed from
Matt Finishes with an application of a carnauba wax based non-abrasive polish on a microfibre cloth. [6] Do not use
undue pressure when cleaning and wipe in one direction only. [7] Contact with harsh chemicals such as hair dye,
hair bleach etc will result in damage to the finish. [8] Tapware should never be installed using acetone silicones. [9]
Avoid the use of wax based furniture creams as this can result in a build up of deposits which will detract from the
appearance. [10] Damage to finishes arising from improper installation or post installation use or failure to observe
the above care and cleaning instructions will void all warranty agreements.
Warranty
Rogerseller tapware, bathroom fittings and sanitaryware are covered by a five (5) year warranty from date
of purchase. For full terms and conditions please refer to rogerseller.com.au
Rogerseller Showrooms —
Melbourne
173-177 Barkly Avenue
Burnley VIC 3121
P 03 9429 8888
Sydney
18 Danks Street
Waterloo NSW 2017
P 02 8396 8700
Brisbane
74–76 McLachlan Street
Fortitude Valley QLD 4006
P 07 3251 4333
Concept Stores —
Southern Innovations
(
Fishwick ACT)
P 02 6143 2666
Southern Innovations
(
Mitchell ACT)
P 02 6129 7666
Southern Innovations
(Albury NSW)
P 02 6022 2777
Routleys Plumbing Innovations
(Malvern SA)
P 08 8291 3000
rogerseller.com.au
