Rogers PRT42, Installation And Programming Manual

Page: 15 / 30

PRT42 and PRT42-BK v1.0 fv72 EN Rev.C
16
5 s
1 s
1 s
6.6 Acoustic and Optical Signalization
Acoustic Signals in Stand-alone Operation Mode
Indication Symbol Description
One long signal ♫ Error indication, unknown card or PIN, access denied.
Two long signals ♫ ♫ Attempt to assign the same function to two different
output lines.
Three beeps ♪♪♪ Command successfully completed (OK Signal).
Two series of three
beeps ♪♪♪ ♪♪♪ Signal OK repeated two times - reader restarted.
Two short signals ♪♪ Prompt (encourage) signal, the reader is waiting for the
next part of the command being entered. This signal is
intended to encourage the programmer to enter next
programming steps.
One long signal
continuously
repeated
♫ ♫ ♫ ♫
… and so on Memory error or MASTER or INSTALLER cards not
programmed - memory reset necessary. This signal is
accompanied by LED SYSTEM steady ON.
Legend:
♫
- one long signal
♪
- One short signal (beep)
LED Indications in Stand-alone Operation Mode
STATUS
LED
OPEN LED
SYSTEM
LED
Meaning
Green — — The reader is in DISARMED state now.
Red — — The reader is in ARMED state now.
Red Green — The reader is in User Programming Mode.
Green Green — The reader is in Installer Programming Mode.
— — Orange
Flashing
Waiting for a user to enter the next part of a command or
programming function.
— — Orange,
one flash
A user card has been read or a user PIN entered.
— Green — Door lock is activated, the LED remains active as long as door lock is
triggered.
— Green
flashing
— The reader is waiting for a user to enter his PIN code.
— — steady The reader has detected some problem (Memory contents is
corrupted or the MASTER/INSTALLER card are not programmed).