Rogers PRT42, Installation And Programming Manual

Page: 12 / 30

PRT42 and PRT42-BK v1.0 fv72 EN Rev.C
13
The reader enters User Programming Mode (the reader’s OPEN LED is ON, the reader’s STATUS LED is
ON and RED).
Do the following: Press [*] [5] (Present a new card to the reader) [#] [#]
The reader has registered the new indicated card in its memory and exited the programming mode.
Once the reader has registered the new indicated card in its memory, it exits the programming mode.
Example 3: Add a new NORMAL User with a specified ID number (ID=87) and an entered PIN code
(PIN=1234) and a presented card
Read MASTER card.
The reader enters User Programming Mode (the reader’s OPEN LED is ON, the reader’s STATUS LED is
ON and RED).
Press [3] [0] [8] [7] and wait for the reader to generate a prompt signal (
♪ ♪
).
Press [1] [2] [3] [4][#], present the card for the user.
Once the reader has registered the new user with an ID=87 and assigned the indicated card and the specified
PIN to him, it exits the programming mode.
Example 4: Delete a user by using his ID=45
Read MASTER card.
The reader enters User Programming Mode (the reader’s OPEN LED is ON, the reader’s STATUS LED is
ON and RED).
Press [9] [4] [5] [#].
The reader deletes the user with ID=45 from its memory, however, it remains in the programming mode, which
allows you to use your next desired programming command.
Example 5: Rearm the reader by presenting a TOGGLE User card
Read your TOGGLE User card; once accepted the reader grants you access and its SYSTEM LED starts
blinking.
With the SYSTEM LED blinking, once more present your TOGGLE card.
The reader changes its arming state (the STATUS LED will change illumination color).
Note: If the Access Disabled When Reader Armed option is enabled and the reader is in ARMED state, then in
order to gain access first you will have to switch the reader to DISARMED state (by presenting twice the
TOGGLE card) and only then use your identification tag once again to open the door.
Example 6: Rearm the reader by entering a TOGGLE User PIN code
Key in the TOGGLE User PIN code; once accepted the reader grants you access and its SYSTEM LED
starts blinking.
With the SYSTEM LED blinking, once more key in the TOGGLE User PIN code.
The reader changes its arming state from ARMED to DISARMED or vice versa (the STATUS LED will change
illumination color).
Example 7: Rearm the reader when the [Card + PIN] verification mode is enabled
Present your TOGGLE User card to the reader then key in the TOGGLE User PIN code; once accepted the
reader grants you access and its SYSTEM LED starts blinking.
With the SYSTEM LED blinking, once more present your TOGGLE card and then key in the PIN.
The reader changes its arming state from ARMED to DISARMED or vice versa (the STATUS LED will change
illumination color).