Rogerblack Silver Medal, Assembly & User'S Instruction

Page: 18 / 40

I
MPORTANT

The console will turn off automatically about
ten minutes after the belt has stopped moving.

The pulse function is for reference only, and
not to be used for medical purpose.
SAFETY KEY

The safety key must be placed into the
magnetic recess on the console in order to
operate the treadmill. Always place the safety
key on its position and attach the clip to your
clothing at your waist before beginning your
workout.

If you should encounter problems and need to
stop the motor immediately, simply pull the
safety key away from the console; to continue
operation, simply turn the power switch to off,
set the speed controller to stop and then
reinsert the safety key into the console.
GENERAL OPERATION
1. Turn on the Power Switch at the front of your
Treadmill. This switch is located next to the
Mains Power Cord inlet.
2. Place the Safety Key into the magnetic recess
on the middle front of the Computer Console.

The console will give an audible signal and all
console window displays with a start display
value of 0.
Note: If the Safety Key is not placed correctly or is
faulty, the center Time window will display "E00",
which indicates that the treadmill will not operate.
If the Safety Key falls off during exercise, the
console will give an audible signal and all console
window displays will reset to display value ―E00‖
and the treadmill will stop.
To stop the treadmill in an emergency, simply pull
the safety key off its mount in the console front or
simply press the red STOP button in the center of
the console. It is important that you connect the
clothing clip to your shirt or other suitable clothing
during exercise to ensure that this safety system
can operate easily.
To get a pre-exercise pulse rate, simply hold both
Hand Pulse Sensors on either side of the
Handlebar Supports for 10 seconds. The Pulse
Range is between 60 ~ 200 Beats per Minute.
Note: The readings displayed by the computer
should not be used for therapeutic purposes as
they can vary due to the sensitivity of the
equipment and the available pulse signal put out
by individuals’ palms. To get the best accurate
readings, keep the hands placed flat and firm on
the PULSE PADS for 10 to 20 seconds, as this will
allow the pulse reading to average and then settle.
Computer Operation
16
Functions and Operations