EN
74
13
Safety input and command status (TEST mode)
;MXLRSGYVVIRXP]EGXMZIGSQQERHWTVIWWXLI8)78FYXXSRERHGLIGOXLIJSPPS[MRK
DISPLAY
POSSIBLE CAUSE
ACTION BY SOFTWARE
PHYSICAL CORRECTIVE ACTION
The safety
STOP
contact is open.
Incorrect setting of parameter
.
Check that parameter
is set cor
rectly
Install a
STOP
button (NC) or jumper the
ST contact with the
COM
contact.
Sensing edge
COS
not connected or
incorrectly connected.
238)ZMWMFPISRP]MJTEV
is
Set the parameter
if not used
or to disable.
Jumper contact
ISEL
with contact
COM
,
if not used or to disable
Photocell
FT1
not connected or in
correctly connected.
Incorrect setting of parameter
.
Set the parameter
and
if not used or to disable.
Jumper contact
FT1
with contact
COM
,
if not used or to disable. Check connec
tion referring to relative connection dia
KVEQƼKYVI
Photocell
FT2
not connected or in
correctly connected.
Incorrect setting of parameter
.
Set the parameter
and
if not used or to disable.
Jumper contact
FT2
with contact
COM
,
if not used or to disable. Check connec
tion referring to relative connection dia
KVEQƼKYVI
SS
If occurs with no voluntary com
mand, the contact (N.O.) may be
faulty or one of the buttons may be
incorrectly connected.
Check
PP - COM
contacts and connec
tions to buttons.
&+
Check
CH - COM
contacts and connec
tions to buttons.
DS
Check
AP - COM
contacts and connec
tions to buttons.
SH
Check
PED - COM
contacts and connec
tions to buttons.
2U
If occurs with no command, the
contact (N.O.) may be faulty or the
timer may be incorrectly connected.
238)ZMWMFPISRP]MJTEV
is
Check
ISEL - COM
contacts. Contact
must not be jumpered if not used.
N.B:
press TEST to exit TEST mode.
We recommend troubleshooting safety device and input status errors with “corrective action by software” only.
