Cerber
®
C41
H
OOKUP
I
NSTALLATION
& P
ROGRAMMING
M
ANUAL
11
After pressing the access code, the system
automatically isolates
the
"Follower"
zones. That is why
the yellow "System" LED will be lit
. After
the Exit time was
over, "delayed" zones
will become "Instant" and they
will trigger an alarm the very moment they are opened.
The red "Armed" LED will blink, indicating that the delayed zones are
"instant" now.
STAY A
RMING
[*] [2] [A
CCESS
C
ODE
]
This arming mode is also used for perimetral protection. This time the user
also stays inside the protected area, but is allowed access through the
Entry/Exit zones.
After pressing the access code, the system
automatically isolates
the
"Follower"
zones. Thus,
the yellow "System" LED will be lit
. After the
Exit time was over, the whole system will arm and the "Armed" LED will stay
lit.
Note:
Entry/exit
and
follower
zones can be programmed for forced arming. So, when
arming, these zones will be bypassed untill they are closed after exit delay
was over.
Forced arming option is necessary in case of leaving the system using a
door which has a magnetic contact mounted on an
entry/exit
zone, the door
being watched by a PIR detector mounted on a
follower
zone. If exit delay is
shorter than the stabilization time of PIR detector, then both zones will be
programmed as being forced armed in order to be bypased when arming the
system. Zone bypassying cancellation will occur when the zones will be
closed (meaning when closing the door at the moment of leaving the
protected area)
D
ISARMING
One can only enter the protected area through an
Entry/Exit
zone. While
opening
Entry/Exit
zone, Entry time will begin counting.
Keypad buzzer will sound a continuous beep during the Entry time, indicating
that the system should be disarmed.
