39
Whenever a memory select piston (M1, M2, M3, or M4) is pressed, a message
appears in the Console Display indicating whether the internal memory or the
Personal Memory Card memory is being used.
If an internal memory is accidentally copied to the Personal Memory Card, or if a
memory level is to be removed on the Personal Memory Card so the internal
memory can be used instead, you can delete the memory level from the Personal
Memory Card.
DELETING A MEMORY FROM THE CARD:
1. Hold General Cancel, then press the memory select tab for the memory level to be
deleted.
2. A message will appear in the Console Display confirming the memory level has
been deleted from the Personal Memory Card. Immediately after this operation,
the internal memory will be “reconnected”.
STORING CRESCENDO SEQUENCES ON THE CARD
In addition to the combination memory levels, the Personal Memory Card can also store
copies of Crescendo sequences. If the Crescendo set operation is performed while the card is
inserted, the new Crescendo sequence will be stored on the card rather than in the internal
memory. Like the combination memory levels, these will automatically replace the internal
Crescendo whenever the Personal Memory Card is inserted in the slot.
DELETING A CRESCENDO SEQUENCE FROM THE CARD:
1. Press “MASTER EXPRESSION/CRESCENDO”.
2. Hold General Cancel, then press “MASTER EXPRESSION/CRESCENDO” again.
A message appears in the Console Display confirming deletion of the stored
sequence from the Personal Memory Card.
STORING ADDITIONAL SETTINGS ON THE CARD
Several additional settings can also be stored on a Personal Memory Card. Changing any
of these settings causes all of them to be moved to the card if they were not previously stored
on the card. The settings will automatically take effect when the card is inserted. The settings
are:
* Melody Note Range
* Master Tuning Lock Status
* Counter Melody Note Range
* Tremulant Adjustments
* Wind Stabilizer Status
* Console Lamp Intensity
* Expression Range Settings
* MIDI Stop Change Send/Receive Enable
