37
2. When the memory contents have been correctly received, the memory tab
corresponding to the memory on the sequencer recording flashes. At this point, the
contents of the memory are stored in a temporary holding area in the console.
3. Stop the sequencer playback.
4. Hold SET, then press the memory tab for the desired destination
. Note: This need
not be the same memory as the memory whose tab is flashing.
When copying more than one memory to the sequencer, it is necessary to wait a few
measures between saving individual memories, or place them on different tracks. This
procedure will reduce confusion regarding the location of the memories on the sequencer.
When playing back the memories, play only one at a time. Each time the organ starts to
receive a new memory, it discards any previous information in the temporary holding area. It
is necessary to transfer each memory to its destination memory in the organ before playing
back the next.
Note: If a Rodgers Personal Memory Card is inserted when recording or playing back
combination memories, and the card memory is in use for the memory level being
saved/restored, the memory will be saved from or restored to the memory card rather than the
internal memory.
MIDI CONNECTIONS
Always connect a sequencer to the Sequencer IN/OUT ports on the organ.
The
sequencer must not be in “Soft Thru” mode.
Any other MIDI instruments or keyboards
should use the ports labeled “MIDI.”
