Rodec MX120, Operating Instructions Manual, Page: 5 / 24

RODEC MX120 RODEC MX126
5
H)
Recording outputs
Outputs to connect cassette recorder or (HIFI) video recorders to make recordings.
I)
AUX output
Output for different apparatuses as integrated amplifiers or recorders.
The output level is 775mV.
J) Equalizer IN/OUT
Terminals to connect audio processors such as a graphic equalizer, compressor or limiter.
When the terminal is not being used, connect the OUT and IN for each channel with a jumper
pin.
WHEN THE SET IS BUILD IN, TAKE CARE THAT THERE’S NOTHING IN CONTACT WITH
THE JUMPERS!!
K)
Master output
Output for slave or power amplifier. The output level can be adjusted with the master fader
(11). The maximum output is 1,5V.
With the balance control (5) you can make the balance between left and right.
If the slave amplifier needs more than 1,5V, the master output can be changed into 3V, by
disconnecting two links inside the set on circuit RC 25 244.
L)
Symmetrical output option
You can add symmetrical earthfree outputs to the panel for a higher quality signal
transmission through the cable between the mixer and the amplifier.
Please use signal cables shorter than 1 meter for the inputs and the outputs.
OPERATING INSTRUCTIONS
1)
Press the power switch (1) to turn the power supply on. The power indicators (2) will light up
and a few seconds later the mixing panel will be in operation, ready state.
2)
Connect the headphones to phones output (7).
3)
Choose with input switch (14) the right source.
4)
Switch the PFL button (8) in position ON to listen at the desired source. With the PFL of this
mixing panel, you can listen to two or more sources at the same time. You can see the
choosen signal on the level meters (3). With the SUM button (8) you can listen to the mixed
signal. All these switches do not change the output signal. Adjust with the level control (13)
the input signal so, that the red indicators of the level meters (3) light sometimes. Adjust if
necessary the quality of the sound with the equalizer (12 on MX120 and 17 on MX126).
PLEASE NOTE : - The equalizer on the MX120 is used to correct the acoustic of the
room.
- The equalizer on the MX126 is used for “beat” mixing or to correct
the differences between the audio sources.
5)
Slide up the fader (9) of the choosen source.
6)
Adjust with the master (11) the output volume.
7)
Correct if necessary the balance with button (5), for monophonic sound set switch (4) in mono
position.
8)
To change the source, repeat point 3) to 5).