Rodec MX120, Operating Instructions Manual, Page: 3 / 24

RODEC MX120 RODEC MX126
3
1)
Do not expose the set to rain or water. Do not spill liquid or insert metal objects inside the set.
Rain, water or liquid such as cosmetics as well as metal, may cause electric shocks, which
can result in fire or shock hazard. If anything gets inside, unplug the power cord.
2)
Frayed cords and broken plugs may cause a fire or shock hazard. Do not damage the power
cord. When removing the power cord from wall outlet, be sure to unplug by holding the plug
attachment and not pulling the cord.
3)
Do not open the set, there are no serviceable parts inside.
Only qualified service technicians can service inside your set.
4)
Operate the set only from a power source which is indicated on the rating label at the back of
the set.
5)
Do not use chemical products to clean the set. Do not use contact spray or other products in
the faders. The contact spray can damage the faders.
INSTALLATION OF THE MIXING PANEL
1)
The set can be used in every position.
2)
Don’t place the set into direct sunlight, or in a warm moist or dusty place.
3)
To avoid disturbances, do not place the set in the neighbourhood of disturbing apparatuses.
FRONTPANEL, SWITCHES AND CONTROL
1)
Power switch
Controls the supply of AC power to the set. One push turns the mixing panel on, a second
push turns it off. It remains in a stand-by mode.
2)
Power / on indicators
These indicators light up when the power is on.
3)
VU meter
These meters indicate the PFL or mixing levels.
4)
Mode Switch
This switch is to be used to set the mixing panel in mono or stereo mode.
5)
Balance control
The balance between the amount of sound on the left and on the right is adjusted by using this
knob. When it is set to the center position, the gain is the same for the left and the right
channel.
6)
Phones control
This button is used to adjust the volume of the headphones.
7)
Phones output
Output for high level headphone monitoring. (Headphones 200-600
Ω
)
8)
PFL switch
This switch is used to listen to any input signal before you fade in this signal.
9)
Channel fader
Volume control for every input.
10) DJ mike fader