USB MICROPHONE
USB MICROPHONE
USB MICROPHONE
USB MICROPHONE
1
Using the optional PSM-1 Shock-Mount
For additional vibration isolation, the Podcaster can be fitted to
the optional PSM-1 ‘spider’ shock mount. The
PSM-1 is a recommended and useful addition to any recording
facility as it significantly reduces unwanted noise transmission to
the microphone. If you have the optional PSM1 shock mount, then
follow the steps below to install the PSM1.
1. First screw the PSM-1 shock mount onto your mic stand, boom
arm or ‘anlgepoise
®
style’ arm. If you’re using a US 5/8” mic stand
or boom, remove the 3/8” insert.
2. Remove the locking collar from the base of the Podcaster and
store it away in a safe place where it will not get lost.
3. Install the Podcaster into the PSM1 by fitting the microphone
into the center of the web and onto the bottom mounting plate
(figure 10). There is a captive locking collar in the centre of the
shock mount which will screw onto the thread on the bottom of
the Podcaster.
4. Rotate the captive locking collar to secure the Podcaster firmly
in the shock mount (figure 11).
5. Loosen the thumb screw on the PSM1 shock mount to adjust the
angle of the Podcaster and position it to the desired location. Once
set, tighten the thumbscrew to secure the Podcaster in place.
Note: Be careful not to over tighten the thumbscrew as this could
cause cross threading and the mount will not maintain the correct
angle if this occurs.
Fig. 10
Fig. 11
