rodac RC120N, User Manual

Page: 7 / 28

1.1. Technical details
USER’S INSTRUCTIONS FOR RC118N / RC119N / RC120N
* The various products are differentiated by the tube length and the extruded product type.
L
H
D
1
1
10
4
6
7 8
8
9
9
3
5 5
6
2
2
3
4
7
2
12
11
1. PRODUCT DESCRIPTION
1) Body of the gun
2) Front ring nut
3) Control lever
4) Handle
5) Pressure regulator
6) Feeding: ¼ gas male threaded connector
7) Material holder tube
8) Dump valve
9) Rear ring nut
10) CE mark
11) Exhaust air outlets
12) Safety hole
7 Manual - English
PNEUMATIC APPLICATOR GUN
Rodac international B.V.
Njverheidsstraat 1 6130 AJ Sittard
MAX PRESSURE 10 bar (145 psi)
mese - anno
Model Basic
setup
Cartridge Soft-pack
Cartridge
(ml)
Soft-pack
(ml)
L
(
mm)
H
(
mm)
D Net
weight
Total
mass
Connec-
tion
Pressure
maxim
RC118N For
soft-pack
≤ 310 ml ≤ 400 ml 307 263 78 1125 g 1420 g
1/4"GAS
maschio
10 Bar
145 psi
RC120N
- - -
≤ 600 ml 440 263 78 1100 g 1365 g
1/4"GAS
maschio
10 Bar
145 psi
RC119N For
cartridge
≤ 310 ml ≤ 400 ml 556 263 78 1300 g 1660 g 1/4"GAS
maschio
10 Bar
145 psi
*
**
* Cartridge based conversion kit : plastic spacer with gasket (included in the supply).
** Bag based conversion kit : bag holder, tube scraper, piston collecting soft-pack, soft-pack awards cone (included in the supply).
1.2. Noise emissions and vibrations
When releasing the lever, the level of equivalent A-weighted sound pressure, measured at a 50 cm. horizontal distance during the
application of a sealant and with a gun feeding pressure of 6 Bar, is > 80 dBA. Therefore the use of ear defenders is recommended.
The hand/arm system vibration level was detected on an equivalent model and it is less than 2,5 m/g2.
1.3. Storage
The gun is supplied in a single KEB WHITE ST/B343 cardboard box, with a 2.8-3 mm. thickness low flute; the gun is held in a
polyethylene bag. Keep at a temperature between -5°C and 45°C, with ambient humidity not exceeding 70%.
2. CAUTION
This symbol draws your attention to safety related issues. Read carefully the recommendations included and strictly comply with them.
Before using the gun read the instructions and strictly comply to them.
Before any repair, maintenance and refill operations, disconnect the air feed.
Before any repair and extraordinary maintenance operations, contact the gun dealer or trained staff. Improper interventions will render
the warranty null and void.
When choosing the product to extrude and before using the gun, check the product compatibility with the work environment and the
adopted individual protection devices, according to its safety data sheet.
During usage, safety devices (individual protections) are to be worn on top of one’s clothes, in compliance with the product safety data
sheet. Using safety glasses and ear defenders is recommended in any case.
During tooling operations hand abrasions may be possible, therefore wearing gloves is recommended.
# Basic setup
: It is the mode with which the gun is assembled at the factory and provided to the client.