9
12V 3in1 SDS RotaRy HammeR
enG
To reduce the risk of injury, user must read
instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
indoor use only
Do not expose to rain or water
Do not burn
Direct current
SymBolS
teCHniCal Data
RK2513K2
Charger voltage
120 V~60 Hz
Voltage
12 V
No load speed
0-900 rpm
impact rate
0-4800 bpm
impact energy
1.0 J
Max. drilling
capacity
steel
5/16˝
Wood
3/8˝
Masonry
3/8˝
Machine weight (with battery)
3.1 lbs
oPeRatinG inStRuCtionS
note:
before using the tool, read the
instruction book carefully.
CHaRGinG
a) CHaRGinG tHe BatteRy PaCK
The battery pack charger supplied is matched to the Li-
ion battery installed in the machine. Do not use another
battery charger.
The Li-ion battery pack is protected against deep
discharging. When the battery pack is empty, the
machine is switched off by means of a protective circuit:
The chuck no longer rotates.
in a warm environment or after heavy use, the battery
pack may become too hot to permit charging. allow time
for the battery pack to cool down before recharging.
When the battery pack is charged for the first time and
after prolonged storage, it will accept only a partial
charge. The battery pack will accept a 100% charge
after several charge and discharge cycles.
B) to RemoVe oR inStall BatteRy PaCK (See a)
Depress the battery pack release buttons to release and
slide the battery pack out from your tool. after recharge,
slide it back into your tool. a simple push and slight
pressure will be sufficient.