Rockwell RD4161, Manual

Page: 9 / 12

9
200W FINISHING SANDER EN
too coarse or applying too much pressure.
MAINTENANCE
Remove the plug from the power source before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not damage your
power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your sander will not operate, check the power at
the mains plug.
2. If the sander does not abrade surface, checking the
sanding paper. If the sanding paper have been worn,
replace the new paper and try again. The paper must
be kept in a dry place, if it is allowed to become
damp, the abrasive particles will lose their adhesion
to the backing paper and will not abrade.
3. If the sander dose not move smoothly, The sanding
paper may be loose, damaged or wrinkled. Replace
and try again.
4. If a fault can not be rectified return the sander to an
authorized dealer for repair.