Rockwell RD4161, Manual

Page: 7 / 12

7
200W FINISHING SANDER EN
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
Warning
RCM marking
ABN: Australian Business Number. By this number,
business information such as entity type, status,
business location etc. can be found at website
http://abr.business.gov.au.
ABN of Positec Australia Pty Ltd is 14 101 682 357
TECHNICAL DATA
Voltage 220-240 V~ 50 Hz
Power input 200W
No load speed 12000 /min
Dimension of base 90*187 mm
Orbital dia. 1.6mm
Protection class:
/II
Machine weight 1.33kg
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
1. FITTING THE SANDING PAPER
WITH HOOK & LOOP SYSTEM (SEE FIG A)
This sander features an easy hook and loop accessory
fastening system for quick changing without clamps.
The sanding papers are placed directly onto the base
plate. The hole pattern in the base plate and sanding
paper must match. Then press the sanding paper
onto the base plate by hand. Firmly press the power
tool with the sanding paper against a flat surface and
briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
Before placing on the sanding paper, free the base
plate from dust/debris by lightly tapping against it.
REMOVE THE SANDING PAPER
Simply lift a small portion of the sand paper from the
side then pull it off the sanding pad.
SANDING PAPER WITHOUT HOOK & LOOP SYSTEM
(SEE FIG B , C , D)
FITTING THE SANDING PAPER
Fitting the sanding paper over the base. Make sure
the sanding paper is even with the edges and that the
dust collection holes in the base and sanding paper is
aligned and that the sanding paper is taut on the base.
Lift the sanding paper retaining clips to the open
position and insert one end of the sanding paper under
the retaining clip.
Push the clip back into the retaining position. Lightly
stretch the paper over the base plate ensuring that it
is not folded or wrinkled then position under the other
retaining clip back into the retaining position. Check
that the paper is flat to the base plate, if not, release
either clip and reposition the paper before resetting the
clip. Switch on momentarily to check that the sander is
functioning correctly. If there is undue vibration, repeat
the paper positioning procedure.
REMOVE THE SANDING PAPER
To remove the sanding paper, lift up the clamp lever
and move away from the clamp lever lock. The sanding
paper clamp is now loose. Repeat with the other clamp
on the opposite side of your sander.