13
CIRCULAR SAW (SKIN)
EN
discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE FIG. A1)
Depress the Battery Pack Release Button (17)
firmly first and then slide the Battery Pack out from
your tool.
C) TO INSTALL THE BATTERY PACK (SEE FIG. A2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
D) HOW TO CHARGE YOUR BATTERY PACK (SEE FIG. A3)
NOTE:
a) Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove
your battery pack from the charger and allow time
for the battery to cool down before recharging.
c) The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time.
d) Please charge the battery to reach full or no less
than half charge before storage. If the tool will
not be used for long periods of time, charge the
battery every 3-6 months
.
Charging procedure
1) Plug the charger into an appropriate outlet. The
light will be green.
2) Slide the battery pack into the charger, the light
will turn to red to indicate the charging process
has started.
3) When charging is completed, the light will turn to
green. The pack is now fully charged, unplug the
charger and remove the battery pack.
WARNING: When battery charge runs out
after continuously use or exposure to
direct sunlight or heat, allow time for the tool to cool
down before re-charging to achieve the full charge.
Light
Status
Red on
Charging
Green on
Fully Charged
Battery charger and battery pack illustrated or
described are not included in RD2914.9 delivery.
ADJUSTMENT
1. CHANGING THE SAW BLADE (SEE FIG. B1, B2, B3)
—
Before any work on the machine itself, remove the
battery.
—
Wear protective gloves when mounting the saw
blade. Danger of injury when touching the saw
blade.
—
Only use saw blades that correspond with
the characteristic data given in the operating
instructions.
—
Do not under any circumstances use grinding
discs as the cutting tool.
For changing the cutting tool, it is best to place the
machine on the face side of the motor housing.
REMOVING
Press the spindle lock button (4) and keep it depressed.
The spindle lock button (4) may be actuated only when
the saw blade is at a standstill.
Loosen the blade bolt (21) in clockwise direction with
the hex key (23). Remove the outer flange (20). Tilt back
the lower blade guard (13) and hold it firmly with the
lower guard lever (12). Remove the saw blade (19).
MOUNTING
Clean the saw blade and all the clamping parts to be
assembled. Tilt back the lower blade guard (13) and
hold it firmly with the lower guard lever (12). Place the
saw blade (19) onto the inner flange (18). Assemble the
outer flange (20) and the blade bolt (21). Use the hex key
to tighten the blade bolt (21) in anti-clockwise direction
with 1/4 turn more than finger tight.
—
Take care that the mounting positions of the inner
flange and outer flange are correct.
—
When mounting: Ensure that the cutting direction
of the teeth (direction of arrow on saw blade) and
the direction-of-rotation arrow on the blade guard
match.
2. ADJUST THE CUTTING DEPTH (SEE FIG.C)
Lift the cutting depth lock lever (24) and raise the saw
body away from the base plate. Set the depth of cut
with the scale and push the lever down to lock. Always
add 3mm to your depth of cut so that the blade can cut
through the material.
3. BASE PLATE ANGLE ADJUSTMENT (SEE FIG. D1, D2)
