Rockwell Automation iTRAK, User Manual

Page: 80 / 124

80 Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019
Chapter 5 Maintenance
Replace Mover Cam-follower Wheels and Flexures
Use this procedure to replace the cam-follower wheels and flexures on a mover.
Before You Begin
What You Need
• 3 mm, 5 mm, and 6 mm hex drivers
• 14 mm socket driver and wrench
• Vise
• Arbor press or similar
• Hard rubber mallet
• Loctite 243
• 2198T-A05 iTRAK TriMax wheel preload tool
• 2198T-AV-WHL-C
x
iTRAK TriMax wheel spare kit
• 2198T-AV-FLX-C
x
iTRAK TriMax flexure spare kit
• Small rod 9 mm (0.35 in.) in diameter
• Flat metal plate approximately 50 x 50 mm (2.0 x 2.0 in.)
To remove the cam followers, complete these steps.
1. Follow Install or Replace a Mover on page 66 to remove the mover from
the track.
2. Cover the magnet plate with cardboard and a magnet keeper plate.
See Magnet Plate Keeper on page 34 for details.
ATTENTION: Before attempting any service to an iTRAK system. See Safety
Information on page 28 .