Rockwell Automation iTRAK, User Manual

Page: 66 / 124

66 Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019
Chapter 5 Maintenance
Install or Replace a Mover
Follow this procedure to install or replace a mover.
Before You Begin
Choose an accessible curved section of the track. Position the mover that you
want to replace over a straight motor module next to the curved section. Move
all other movers off the curved end of the track.
What You Need
• Left and right straight-to-curved clamps from 2198T-A04 iTRAK
alignment tool kit
• 4 mm hex driver
• Loctite 243
• 2198T-A03, pair of mover installation fixtures
• 2198T-VT
xxxx
-C, mover
To remove a mover, complete these steps.
1. Remove the position magnet assembly by following the procedure
Install or Remove a Position Magnet Assembly on page 62 .
ATTENTION: Before attempting any service to an iTRAK system. See Safety
Information on page 28 .