Rockwell Automation iTRAK, User Manual

Page: 64 / 124

64 Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019
Chapter 5 Maintenance
Magnet Plate Assembly Installation
Follow this procedure to install or remove a magnet plate assembly.
Before You Begin
What You Need
• 6 mm hex driver
• Loctite 243
• 2198T-M
xxxx
-A000, magnet assembly
• M6 x 25 socket head cap screws and M6 x 30 flat head socket screws as
shown in Table 20 .
ATTENTION: Before attempting any service to an iTRAK system. See Safety
Information on page 28 .
ATTENTION: If you are using your own design for a mover, make sure of the
following.
• The mounting hardware is not too long that it protrudes past or pops
through the magnet plate.
• Be sure to use all mounting holes. By using all mounting holes, the magnet
maintains correct orientation of north-south magnet polarity.
Table 20 - Screws Required for Mounting Magnet Plates
Cat. No. FHCS M6 x 30
Quantity
SHCS M6 x 25
Quantity
2198T-M0505-A000 3 -
2198T-M0510-A000 2 3
2198T-M0515-A000 2 3
2198T-M1005-A000 3 -
2198T-M1010-A000 2 3
2198T-M1015-A000 2 3
2198T-M1505-A000 2 3
2198T-M1510-A000 2 3
2198T-M1515-A000 2 3