Rockwell Automation Allen-Bradley PowerFlex 20-750-EMC2-F5, Installation Instructions Manual

Page: 1 / 20

Installation Instructions
Original Instructions
PowerFlex 755T Frames 5 and 6 EMC C2 Filter Kits
Catalog Numbers 20-750-EMC2-F5, 20-750-EMC2-F6
The frame 5 and 6 EMC C2 filter kits are used for PowerFlex® 755T product installations that require compliance with CE EN61800-3 Category
C2 for conducted emissions only. The EMC C2 filter kits cannot be used for ungrounded/high resistance ground or marine ungrounded/high
resistance ground applications. Review the instructions in the PowerFlex 750-Series Products with TotalFORCE® Control Installation Instructions,
publication 750-IN100 , to become familiar with your installation requirements before completing these instructions.
Summary of Changes
This publication contains new and updated information as indicated in the following table.
Product Advisories
Topic Page
Summary of Changes 1
Product Advisories 1
Required Tools 2
Frame 5 EMC C2 Filter Kit Contents (Cat. No. 20-750-EMC2-F5) 2
Frame 5 EMC C2 Filter Installation 3
Frame 6 EMC C2 Filter Kit Contents (Cat. No. 20-750-EMC2-F6) 9
Frame 6 EMC C2 Filter Installation 10
Additional Resources 20
Topic Page
Added a Phillips screwdriver/bit to the Required Tools table. 2
Added the debris hood and cable clamps to the Frame 5 EMC C2 Filter Kit Contents (Cat. No. 20-750-EMC2-F5) section. 2
Updated the product dimensions in the Frame 5 EMC C2 Filter Kit Contents (Cat. No. 20-750-EMC2-F5) section. 2
Added step 14 and step 18 to the Frame 5 EMC C2 Filter Installation instructions. 8
ATTENTION: Only qualified personnel, which are trained and approved to install PowerFlex 755T products and familiar with associated machinery, should plan
or implement the installation, startup, and subsequent maintenance of the system. Failure to comply can result in personal injury and/or equipment damage.
ATTENTION: The information that is contained in this publication is merely a guide for proper installation. Rockwell Automation, Inc. cannot assume
responsibility for the compliance or the noncompliance to any code, national, local or otherwise for the proper installation of this drive or associated equipment.
A hazard of personal injury and/or equipment damage exists if codes are ignored during installation.
ATTENTION: This product contains Electrostatic Discharge (ESD) sensitive parts and assemblies. Static control precautions are required when you install these
assemblies. Component damage can result if ESD control procedures are not followed. If you are not familiar with static control procedures, reference any
applicable ESD protection handbook.