Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 52 / 104

52 Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019
Chapter 4 Install and Operate the Junction Boxes
IP65 Junction Box Status Indicator Lights
The front of each IP65 junction box has three status indicators and a status
indicator bar.
Table 8 explains what each color signifies on the lights and status indicator bar.
Table 8 - IP65 Junction Box Status Indicators and Bar Colors
Indicator Color Displayed Status Indicated
Power Green Power is present and the IP65 junction box is ready for operation.
No color No power is present or there is a fault during startup.
Illuminated
E-stop Green A second generation MobileView terminal with an illuminated E-stop
button is connected to the junction box.
No color A second generation MobileView terminal without an illuminated E-stop
button is connected to the junction box.
Ethernet Green The junction box is connected to an Ethernet network.
No color The junction box is not connected to an Ethernet network.
Status
indicator
bar
(1)
(1) The IP65 junction box must have power (green at power status indicator) for the status bar to display status.
Solid green A second generation MobileView terminal with an E-stop button is
connected correctly and the E-stop has not been pressed.
Solid white No second generation MobileView terminal is connected but a 22-pin
bridge connector is connected correctly.
Blinking white No second generation MobileView terminal or 22-pin bridge connector is
connected to the junction box.
Solid yellow Begins the disconnect count time of 10 seconds after a second generation
MobileView terminal or 22-pin bridge connector is disconnected from the
junction box.
Partial yellow Going from right to left, a light on the status bar shuts off after 1.67 seconds
of disconnect time has passed. For example, only three of the six lights
remain lit after five seconds of disconnect time.
Blinking yellow When no plug is connected after 10 seconds, the disconnect timeout forces
the junction box into a safe mode.
Solid red An E-stop button on a second generation MobileView terminal has been
pressed and safe mode is activated.
ATTENTION: Other colors signify when a second generation MobileView terminal or IP65
junction box are in an error state. To identify these colors, see Troubleshoot the IP65 Junction Box
on page 90 .
Power
Illuminated
E-stop
Status Indicator
Bar
Ethernet