Rockwell Automation Allen-Bradley LDAT-S03 Series, User Manual

Page: 54 / 76

54 Rockwell Automation Publication LDAT-UM001A-EN-P - April 2016
Chapter 5 Maintenance
Replace the Encoder
1.
Remove the encoder by following procedure on page 60 .
2.
Install the encoder by following procedure on page 61 .
3.
Check the encoder by following procedure on page 61 .
4.
Run the Hookup test by following procedure on page 62 .
Replace the Encoder Scale
1.
Disassemble the linear thruster by following procedure on page 54
2.
Remove the encoder scale by following procedure on page 62 .
3.
Mount the encoder scale by following procedure on page 61 .
4.
Assemble the linear thruster by following procedure on page 56
5.
Check the encoder by following procedure on page 61 .
6.
Do the Hookup test by following procedure on page 62 .
Disassemble the Linear Truster
Follow this procedure to disassemble your linear thruster.
1.
If your linear thruster has the strip cover option, follow Remove Strip
Cover procedure on page
59 .
2.
Loosen the shipping and handling set screw.
3.
Remove the coil screws.
4.
Remove the bearing screws.
TIP Use non-magnetic tools and hardware made of beryllium copper, 300 series
stainless steel. If these tools are not available, go ahead carefully as the
magnet track attracts magnetic and ferrous items.