![Rockwell Automation Allen-Bradley 193-DNENCAT User Manual Download Page 31](http://html1.mh-extra.com/html/rockwell-automation/allen-bradley-193-dnencat/allen-bradley-193-dnencat_user-manual_1475766031.webp)
Rockwell Automation Publication 193-UM014A-EN-P - July 2011
31
Chapter
4
2.
Change the node address using the appropriate mechanism for the new
device.
Using the DeviceNet Commissioning Tool
A device’s network node address can be set using the Node Commissioning Tool
on the EtherNet/IP Communications Auxilliary web page. This tool uses the
Network Who to view the DeviceNet modules on the network.
Refer to the following guidelines when using the Network Commissioning tool.
•
Only use this tool with an online DeviceNet network.
•
Only use this tool when adding new devices to the network if :
–
the new device
does not
feature a hardware mechanism to set the node
address
or
–
the new device’s node address needs to be set higher than 63.
•
Each time a new device is added to the DeviceNet network, the procedures
beginning on
must
be performed.
•
To avoid conflict with duplicate node addresses, due largely in part to
module having a factory node setting of 63, add and configure a module to
the online DeviceNet network one a time.
•
Record the node address for each device that is set by the Node
Commissioning Tool.
Complete the following steps to set a device’s node address using the Node
Commissioning Tool on the EtherNet/IP Communications Auxilliary web page.
Mechanism
Procedure
Rotary Switch
Turn the rotary switch dials to the desired node address value.
Usually, a small, flathead screwdriver is needed to turn the dials.
Once the device is powered up, the rotary switch settings are
recognized. If the set node address value needs to be changed,
power down the device, turn the dials to the desired setting, then
power up the device again.
Push Wheel Switch
Turn the push wheel to the desired node address value.
NOTE:
If the new device features a hardware mechanism and the node address
is set at 63 or lower, the Network Commissioning tool
does not
change
the device’s node address.
2
4
6
0
PGM
MSD
2
4
6
0
LSD
8
Summary of Contents for Allen-Bradley 193-DNENCAT
