Rocks OK-03.4312, Manual, Page: 9 / 32

9
Removing the battery:
1. Press the lock buton
2. Pull out the battery
DEVICE
The battery must be disconnected from the tool when preparing the tool for work, when installing
and changing accessories. The tool should be kept clean, especially in technically important places:
switches, switches, connection with the battery, accessories holder, housing around the engine,
ventilation openings. Contamination of these places can lead to permanent damage to the tool.
Clean tools with a clean, damp cloth and blow with air.
The work procedure is as follows.
Installation of the silicone cartridge
Switching on and regulating the working speed
1. Press the plunger release button:
(5) and keep it pressed
2. With your other hand, pull the plunger
out while holding it, and the handle: (6)
3. Insert the cartridge into the cartridge
tube and push the piston towards the
cartridge to the required depth.
4. To remove the cartridge, press the button (5)
and pull the plunger out by the handle (6)
5. Remove the cartridge.
1. Press the main switch (7) to turn on the device.
When you release it, the device will stop and gently
retract the plunger to stop the flow of silicone
2. The gun is equipped with a switch lock. To unlock
it, slide the lock button down
3. Set the speed control with the knob (6). Marking
1 on the knob is the slowest discharge of silicone mass,
marking 6 is the fastest discharge of silicone.
4. Correct regulation of the outflow speed allows for
laying an even and tight line of the sealing compound.
5. Cartridges with a thick mass and a small discharge
opening require a lot of pressure from the plunger.
This gun has a pressure of 2,500 N. The force affects
the discharge speed of the battery.